Programmable features, Electronic vehicle information center (evic), Key fob programmable features – Ram Trucks 2012 Chassis Cab - User Guide User Manual
Page 55: Electronics

PROGRAMMABLE FEATURES
Electronic Vehicle Information Center (EVIC)
• The EVIC can be used to view or change the following settings. Press the UP
or DOWN
button until System Setup displays, then press the SELECT
button. Scroll through the settings using the UP or DOWN buttons. Press
the SELECT
button to change the setting. Press the BACK button to scroll
back to a previous menu or sub menu.
• Select Language
• Headlamp Off Delay
• Nav-Turn By Turn
• Headlamps With Wipers
• Auto Unlock Doors
• Easy Exit Seat
• Remote Unlock Sequence
• Tilt Mirror In Reverse
• RKE Linked To Memory
• Key-Off Power Delay
• Remote Start Comfort Sys.
• Illuminated Approach
• Horn With Remote Start
• Compass Variance
• Sound Horn With Lock
• Calibrate Compass
• Flash Lamps With Lock
Key Fob Programmable Features
• The following features may also be programmed by using the Key Fob
transmitter or the ignition switch and driver's door lock switch.
NOTE: Pressing the LOCK button while you are inside the vehicle will activate the
Vehicle Security Alarm. Opening a door with the Vehicle Security Alarm activated
will cause the alarm to sound. Press the UNLOCK button to deactivate the Vehicle
Security Alarm.
Unlock On First Press
• To unlock either the driver's side, or all doors, on the first press of the
UNLOCK button:
• Press and hold the LOCK button for at least 4 seconds, but no longer than
10 seconds. Then, press and hold the UNLOCK button while still holding the
LOCK button.
• Release both buttons at the same time.
Auto Unlock Doors On Exit
• To have all of the vehicle doors unlock when any door is opened:
• Enter your vehicle, close all the doors and fasten your seat belt.
• Within 15 seconds, cycle the ignition switch from the OFF position to the ON
position a minimum of five times, ending in the ON/RUN position (do not start
the engine).
• Within 30 seconds, press the driver’s door lock switch in the UNLOCK
direction. A single chime will indicate that programming is complete.
ELECTRONICS
53