Uconnect™ phone, Phone pairing, Electronics – Ram Trucks 2012 Chassis Cab - User Guide User Manual
Page 49: Warning

NOTE:
• The USB port supports certain Mini, Classic, Nano, Touch, and iPhone
®
devices.
The USB port also supports playing music from compatible external USB Mass
Storage Class memory devices. For supported audio file formats, refer to the
USB Port section on the Owner's Manual on the DVD. Refer to
www.UconnectPhone.com website for a list of tested iPod
®
s. Some iPod
®
software versions may not fully support the USB port features. Please visit
Apple’s website for iPod
®
software updates.
WARNING!
Do not plug in or remove the iPod
®
or external device while driving. Failure
to follow this warning could result in a collision.
Uconnect™ Phone
• To determine if your vehicle is equipped with Uconnect™ Phone, press the
“Uconnect™ Phone” button
. If your vehicle has this feature, after a couple
seconds you will hear a voice prompt. If not, you will see a message on the
radio “Uconnect phone not available”.
• The Uconnect™ Phone is a voice-activated, hands-free, in-vehicle
communications system with Voice Command Capability (see Voice Command
section).
NOTE: To access the tutorial, press the “Uconnect™ Phone” button
. After the
BEEP, say “tutorial”. Press any hard-key/button or touch the display (Touch-Screen
radio) to cancel the tutorial.
• The Uconnect™ Phone allows you to dial a phone number with your mobile
phone using simple voice commands.
• Refer to your vehicle Owner's Manual on the DVD for further details.
NOTE: The Uconnect™ Phone requires a mobile phone equipped with the
Bluetooth
®
Hands-Free Profile, Version 1.0 or higher. For Uconnect™ customer
support, call 1–877–855–8400 or visit www.UconnectPhone.com.
Phone Pairing
NOTE: Pairing is a one-time initial setup before using the phone.
• Press the “Phone” button
to begin.
• Wait for the “ready” prompt and BEEP.
• (After the BEEP), say ”setup” or “Uconnect device setup”.
• (After the BEEP), say “device pairing”.
ELECTRONICS
47