Ram Trucks 2010 3500 - User Guide - Manual (Page 20)

PROGRAMMABLE FEATURES
Electronic Vehicle Information Center (EVIC) – If Equipped
• The EVIC can be used to program the following Personal Settings. Press the UP or
DOWN button until SYSTEM SETUP displays, then press the SELECT button .
Scroll through the settings using the UP or DOWN button. Press the SELECT button to
change the setting.
• Select Language • Headlamps With Wipers
• Nav-Turn By Turn • Automatic High Beams – If Equipped
• Park Assist System • Wiper Mode – If Equipped
• Auto Door Locks • Easy Exit Seat – If Equipped
• Auto Unlock Doors • Tilt Mirror In Reverse
• Remote Unlock Sequence • Key-Off Power Delay
• RKE Linked To Memory • Illuminated Approach
• Remote Start Comfort Sys. • Hill Start Assist (HSA)
• Horn With Remote Start • Display Fuel Saver – If Equipped
• Horn With Remote Lock • Compass Variance
• Flash Lamps With Lock • Calibrate Compass
• Headlamp Off Delay
Key Fob Programmable Features
• The following features may also be programmed by using the Key Fob transmitter or
the ignition switch and driver's door lock switch.
NOTE: Pressing the LOCK button while you are inside the vehicle will activate the
Vehicle Security Alarm. Opening a door with the Vehicle Security Alarm activated will
cause the alarm to sound. Press the UNLOCK button to deactivate the Vehicle Security
Alarm.
Unlock On First Press
• To unlock either the driver's side, or all doors, on the first press of the UNLOCK button:
• Press and hold the LOCK button for at least 4 seconds, but no longer than
10 seconds. Then, press and hold the UNLOCK button while still holding the LOCK
button.
• Release both buttons at the same time.
Auto Unlock Doors On Exit
• To have all of the vehicle doors unlock when any door is opened:
• Enter your vehicle, close all the doors and fasten your seat belt.
• Within 15 seconds, cycle the ignition switch from the OFF position to the ON
position a minimum of four times, ending in the OFF position (do not start the
engine).
• Within 30 seconds, press the driver’s door lock switch in the UNLOCK direction. A
single chime will indicate that programming is complete.
GETTING STARTED
18