Pro Boat PRB4100 - Manual (Page 6)

6
About your Speed Controller
Be sure to use a Programming Module
(PRB3311) to adjust the cutoff voltage when
using Li-Po batteries to protect against over-
discharging the batteries.
Note: The ESC is factory-set for use with
Ni-MH batteries.
The programming module offers other
beneficial adjustments like exponential
throttle curves and timing adjustments. Visit
ProBoatModels.com and search "Programming
Module" for further details.
 10. Confirm that the ESC on/off switch
is in the "OFF" position and connect the
batteries to the battery plugs from the
speed control.
 11. Turn on the transmitter, then the ESC
on/off switch. The ESC will beep until you
pull the throttle trigger to full throttle and
return it to the neutral position. Check the
operation of the propeller in relationship
to the throttle trigger. When the trigger
is pulled in, the propeller must rotate
counterclockwise as shown. If the motor
turns in the wrong direction, switch any 2
motor wires.
 12. Check the operation of the steering in
relationship to the steering wheel. When
the wheel is rotated clockwise, the rudder
must move right as shown. If not, follow
the instructions from the radio to set the
servo reversing for the steering.