Basic assembly – Pro Boat PRB4100 User Manual

Page 4

Required Equipment and Accessories
Transmitter

AA battery (4)

Motor battery (2) (charged)

Hook and loop tape



1. Locate the pieces for the boat stand.

The longer side pieces will key to the

shorter end pieces. Use a small amount of

Medium CA to glue the pieces together.



2. Slide the cover from the bottom of the

transmitter to access the battery holder.



3. Install the four AA batteries in the

battery holder. Match the polarity of the

batteries to the molded markings in the

battery holder.



4. Slide the battery cover back on the

bottom of the transmitter.



5. Lift the hatch cover from the hull at

the rear and slide it back to remove.

The cover is held at the rear using two

magnets, and at the front with a small pin.

Basic Assembly