Pro Boat PRB4075 - Manual (Page 5)

5
Required Equipment and Accessories
Hull assembly
Receiver
Speed control Antenna tube
Hook and loop tape
Note: Steps 4 through 5 relate only to
the RTR version of the Mystic. Please
refer to the instructions provided with
your particular radio system if assembling
the PNP version of this model.
 1. Lift the hatch cover from the hull at
the rear and slide it back to remove.
The cover is held at the rear using two
magnets, and at the front with a small pin.
 2. Remove the radio box cover from the
hull by lifting it up using the tab at the
rear of the cover.
 3. Use hook and loop tape to secure the
receiver in the hull. The lead from the
steering servo plugs into the STR port, and
the speed control plugs into the THR port.
 4. Pass the longer antenna wire through
the fitting on the top of the hull. The
antenna wire is then inserted into the
antenna tube. Place the antenna tube in
the fitting to complete the main antenna
installation.
 5. Use clear tape to secure the shorter
feed antenna under the lip of the hull.
Make sure the tape will not interfere with
the installation of the radio box cover.
Receiver and Speed Control Installation