Pro Boat PRB4000BDC - Manual (Page 4)

4
Required Equipment and Accessories
Transmitter with batteries
Motor batteries (charged)
Hook and loop tape
 1. Locate the pieces for the boat stand.
The longer side pieces will key to the
shorter end pieces. Use a small amount of
Medium CA to glue the pieces together.
 2. Loosen the fittings securing the hatch
to the hull. Pull the rear of the hatch
away from the hull slightly and then
forward to remove it from the hull.
 3. Remove the clear battery cover from
the hull. Place the motor batteries in the
hull. The rear battery fits under the speed
control, and the forward battery lays flat
in the radio compartment. This keeps the
center of gravity low for the best handling
of your model. Use the hook and loop
tape supplied with your model to keep the
batteries from moving in the hull.
Note: Make sure to center the trims for
both the steering and throttle on your
transmitter.
 4. Move the switch on the transmitter to
the ON position. Connect the batteries to
the battery plugs from the speed control.
Be sure to use a PRB3311 Programming
module to adjust the cutoff voltage when
using Li-Po batteries to protect against over
discharging the batteries.
Basic Assembly