Pro Boat PRB4000BDC - Manual (Page 10)

10
Checking the Steering Setscrews
It may be necessary to tighten the setscrews
attaching the steering arm and shaft to the
motor mount if your boat is proving difficult
to trim or the steering is sloppy. To access
the setscrews you will need to remove the
motor from the mount.
 1. Use a 3mm hex wrench and 7mm open
end wrench to remove the two bolts that
attach the motor to the mount.
 2. Use a 1.5mm hex wrench to tighten
the setscrews securing the motor mount
to the steering shaft. Use threadlock
on the setscrews to prevent them from
vibrating loose.
 3. Use a 1.5mm hex wrench to tighten
the setscrew securing the steering arm
to the steering shaft. Use threadlock on
the setscrew to prevent it from vibrating
loose.