Pro Boat PRB3400 - Manual (Page 8)

8
 1. Loosen the 1.5mm setscrew connecting the
drive shaft to the motor coupler.
 2. Loosen the 1.5mm setscrew connecting the
universal joint to the drive shaft.
 3. Remove the two 3mm screws from the
outdrive to separate the rudder assembly from
the mount. Make sure not to lose the 3mm nuts
when removing the screws.
 4. Move the rudder assembly and slide the drive
shaft out of the stuffing box.
 5. Lubricate the drive shaft with drive shaft
with PRB0100 Marine Grease. Reinstall the
drive shaft in reverse order. Be sure to reinstall
the nylon washer between the universal and
the stuffing box.
Note: Running the Apache 24
EP RTR in salt water could cause
some parts to corrode. If you
run the boat in salt water, rinse it
thoroughly in fresh water after each
use and lubricate the drive system.
Section 9: Lubricating the Drive Shaft