Pro Boat PRB3400 User Manual

Page 4

Text mode
Original mode

Install 8 “AA” alkaline batteries into the
transmitter, following the instructions provided
for your radio system.

Turn on the transmitter, making sure that all three
LEDs illuminate on the power indicator and that
the trim knobs are in the center position. Turn the
transmitter off.

Carefully remove the hatch (scale
pilot cockpit).

Make sure the receiver switch is in the "OFF"
position. Install a fully charged 7.2V Ni-Cd battery
pack into the radio box. Follow the instructions
included with your fast charger to ensure a safe
charge. Plug the battery into the female battery
connector attached to the electronic speed
controller.

Section 1: Installation of the Transmitter Batteries

Section 2: Installation of the 7.2V Ni-Cd Battery Pack