Pro Boat PRB2450S - Manual (Page 6)

6
 8. Carefully unwrap the top, side rigging
lines.
 9. Insert the side rigging line into the
outer hole in the spreader as shown.
Note : The spreader has a small notch
in the outer hole. The inner hole will
not be used, making it easier to insert
the line. Simply push the rigging line
through the slot.
 10. Open the rigging clip and attach it to
the eye plate marked "C, D." Close the
wire clip.
 11. Carefully unwrap the mid-line rigging
marked "D."
 12. Open the rigging clip and attach it to
the eye plate marked "D." Close the wire
clip.
Section 2 – Rigging Installation