beautypg.com

Pro Boat PRB2450S User Manual

Page 10

background image

10

Section 6 – Checking the Radio System

Turn on the radio system and test it to make

certain it is functioning correctly. First, turn

on the transmitter. Next, turn on the switch

that controls the receiver.

• Moving the right stick of your transmitter

will control the rudder. To turn to the right,

simply move the stick to the right, and the

rear of the rudder should also move to the

right. Do the opposite to turn left.

• Moving the left stick of the transmitter will

control the sails. By moving the left stick

upward, you will let the sails out. By

pulling the left stick down, you will tighten

the sails.

• Once the sails are pulled in, with the sail

control in the fully lower position, move the

sail trim adjustment toward the bottom of

the transmitter to operate the motor.

• When the radio system is working correctly

and the sails and fittings are properly

adjusted, you are ready to sail.

• After sailing, turn the receiver off before

turning the transmitter off.

Never sail with the sail trim adjusted to a

position that will allow the motor to turn on.

Note

: The motor is for intermittent use

only. If you notice the power slowing,

stop motor use immediately and

recharge the battery. Continued use

will cause the radio system to lose

control.