Pro Boat PRB2450S - Manual (Page 5)

5
 5. Locate the main sail boom. Slide the
screw through the eyelet and use a
Phillips screwdriver to secure the end of
the boom. Do not over tighten as the sail
boom will move as the sails are adjusted.
Apply a drop of threadlock on the nut and
thread it onto the screw from the bottom
of the boom mount.
 6. Locate the end of the main sail marked
"G". Pass the line tied to the main sail
through the hole in the rear end of the
main sail boom. Pull the line until the
main sail is taut, and the distance
between the boom and sail is between
3/4-inch and 1 1 /
4
-inch. Secure the excess
line by wrapping it around the cleat and
placing the end of the line in the notches
of the cleat.
 7. Locate the other end of the main sail.
Pass the line tied to the main sail through
the hole in the boom mount. Position the
line so the distance between the boom
and sail is equal to the other side of the
sail. Secure the excess line by wrapping it
around the cleat and placing the end of
the line in the notches of the cleat.
Note : Do not adjust the tension of any
of the lines at this time. This will be
done in Section 4, “Adjusting the
Rigging Cables.”
Section 2 – Rigging Installation