Pro Boat PRB2200 V.1 - Manual (Page 5)

5
Section 1: Receiver and Transmitter Battery Installation
Receiver Batteries
 1. Remove the two knurled aluminum nuts that
secure the cockpit as shown. Pull the cockpit off
the boat.
 2. Carefully note how the exhaust system
is assembled.
 3. Use a 2.5mm hex wrench to remove the
tuned pipe mount as shown.
 4. Carefully remove the tuned pipe by sliding the
silicone coupler apart from the exhaust header
 5. Remove the clear lid that covers the
radio box.
 6. Remove the dry cell battery holder from the
radio box and unwrap the foam around the
dry cell battery holder. Install 4 “AA” alkaline
batteries into it as shown. Note the proper
polarity. Wrap the battery box in foam.