Pro Boat PRB2050T - Manual (Page 4)

Re-install the battery holder into the radio box and
properly seal the radio box with clear tape. Failure
to properly seal the radio box could result in damage
to your radio equipment. Insert the reciever antenna
tube into the clear lid.
Remove the transmitter from the box.
Remove the battery cover on the bottom of transmitter.
Note the proper polarity and insert 8 “AA” batteries into
the transmitter.
Turn on the radio and confirm that all LEDs illuminate,
indicating proper installation of fully charged batteries.
Turn the radio off.
Transmitter Batteries
4
Section 1: Installation of Receiver and Transmitter Batteries
Remove the knurled aluminum nut that secures the
cockpit. Pull the cockpit off the boat.
Remove the clear lid that covers the radio box.
Remove the dry cell battery holder from the radio box and
unwrap the foam from around the dry cell battery holder.
Install 4 “AA” alkaline batteries as shown. Note the proper
polarity. Wrap the battery box in foam.
Receiver Batteries
Antenna
Tube