Pro Boat PRB09003 User Manual

Page 9

Owner’s Manual

Vehicle Starting and Running

Breaking in the Engine

CAUTION: Make sure you understand all engine instructions before attempting to start the engine.

Failure to follow all instructions can lead to damage to your vehicle, property damage and bodily injury.

CAUTION: Always keep all body parts, hair and dangling or loose items away from a spinning propeller, as these

could become entangled.

1. Remove the canopy.
2. Power on your transmitter, then power on the

receiver.

3. Press the priming bulb several times until it becomes

filled with fuel. This is not necessary if the engine has

been run recently.

4. With the boat on a stand and the propeller unobstructed,

pull the starter cord in a quick continuous motion to start

the engine. The engine should start within 6 pulls.

5. Replace the canopy before placing the boat in the

water.

Break in the engine by running slowly for the first half

tank of fuel (about 25 minutes).

NOTICE: Do not adjust carburetor settings during

break-in. Doing so will cause engine damage.

When the boat is moving forward, ensure water flows

out of the coolant outlets. If water is not flowing out of

the coolant outlets, remove any blockage from the rudder

inlet and coolant system or the engine and tuned muffler

may overheat.