Pro Boat PRB09003 - Manual (Page 11)

Owner’s Manual
Steering Trim
Use the ST. Trim knob on the transmitter to adjust the
steering trim to center the rudder. If the servo arm is
not close to its desired neutral position after the binding
process and the rudder cannot be centered using trim,
please take the following steps:
1. Make sure the ST. Trim knob is set to “0” or neutral.
2. Adjust the linkage to the servo so the rudder is
centered when the steering is at neutral.
Throttle Trim
Adjust the TH. Trim so the carburetor is completely
closed when the throttle trigger is at neutral. If throttle
can not be closed using TH. Trim, please take the
following steps:
1. Make sure TH. Trim knob is set to “0” or neutral.
2. Use needle-nose pliers or ball link pliers (RVO1005) to
remove or install a link on a control horn.
3. Turn the linkage clockwise or counterclockwise until
the throttle is closed.
4. Attach the linkage to the control horn after
adjustment.
NOTICE: Throttle trim change may affect engine
operation. Carburetor settings must be set correctly or
damage may result.
After Boating
• Drain water from inside the hull using the drain plug
• Wipe exhaust residue from the boat
• Rinse the deck, hull, and metal hardware with fresh
water, then dry them with a clean towel. After
cleaning, coat metal hardware with a silicone spray
lubricant to help prevent corrosion
• Fully dry the inside and outside of the boat, including
the water cooling system. Remove the hatch before
storing your boat
• Apply a wax coating for automotive finishes to your
boat to prevent oxidation and to protect against
damage caused by fuel or other harmful chemicals
• Repair any damage or wear to the boat
• Lubricate the flex shaft
• Make note of lessons learned from the trimming of
your boat, including water and wind conditions
NOTICE: When you are finished boating, never leave
the boat in direct sunlight or in a hot, enclosed area such
as a car. Doing so can damage the boat.
11
EN