Warning – Craftsman 137.21239 User Manual

Page 23

THE LASER BEAM

For your own safety, never connect
the plug to power source outlet
until all the adjustment steps
are complete and you have read
and understood the safety and
operational instructions.
Your tool is equipped with the Laser
Trac

cutting

guide using Class II laser beam. The
laser beam will enable to preview the
saw blade path on the stock to be cut
before starting the miter saw. This laser
guide is powered by the transformed
alternating current supply directly
through the power lead. The saw must
be connected to the power source
and the laser on/off switch must be
turned on for the laser line to show.

●

AVOID DIRECT EYE CONTACT

Laser radiated when laser guide
is turned on. Avoid direct eye
contact. Always un-plug the miter
saw from power source before
making any adjustments.

●

Laser Warning Label: Max output

<1mW DIODE LASER: 630-670
nm, Complies with 21CFR 1040.10
and 1040. 11.
CLASS II LASER PRODUCT.

●

NOTE: All the adjustments for the

operation of this machine have
been completed at the factory.
Due to normal wear and use,
some occasional readjustments
may be necessary.

●

CAUTION-Use of controls or

adjustments or performance of
procedures other than those
speciﬁ ed herein may result in
hazardous radiation exposure.

●

CAUTION-The use of optical

instruments with this product will
increase eye hazard.

●

Do not attempt to repair or

disassemble the laser. If
unqualiﬁ ed persons attempt
to repair this laser product,
serious injury may result. Any
repair required on this laser
product should be performed
by authorized service center
personnel.

WARNING