Tools needed for assembly – Craftsman 137.21239 User Manual
Page 13
13
COMBINATION SQUARE MUST BE
TRUE
Should not gap or overlap when square
is fl ipped over (see dotted fi gure).
Should not gap or overlap
when square fl ipped over
(see dotted fi gure).
Draw light line
on board along
this edge.
Straight edge or a 3/4 in.
board, this edge must be
perfectly straight.
Phillips Screwdriver
Blade Wrench
Adjustable Wrench
Hex Key
Combination Square
Supplied
Not supplied
Slotted Screwdriver
TOOLS NEEDED FOR ASSEMBLY
See also other documents in the category Craftsman Power saws:
- TS3650 (8 pages)
- 113.24181 (40 pages)
- 572.24700 (6 pages)
- 137.21194 (44 pages)
- 118.22000 (15 pages)
- 137.21807 (56 pages)
- 113.244513 (20 pages)
- 315.24234 (42 pages)
- 509347 (48 pages)
- 351.21833 (12 pages)
- 113.298761 (56 pages)
- 137.248830 (31 pages)
- 113.2472T0 (40 pages)
- 286.17589 (48 pages)
- 137.218030 (30 pages)
- 137.21602 (36 pages)
- 509399 (52 pages)
- 137.21236 (29 pages)
- CONTRACTOR 351.21833 (36 pages)
- 286.25574 (48 pages)
- 286.26829 (46 pages)
- 315.220381 (82 pages)
- 113.248510 (52 pages)
- 315.235380 (38 pages)
- 315.228110 (54 pages)
- 315.212220 (39 pages)
- 137.212290 (28 pages)
- 917.27103 (60 pages)
- 315.216360 (26 pages)
- 172.267700 (18 pages)
- 315.108330 (20 pages)
- 315.108990 (20 pages)
- 315.212080 (36 pages)
- 315.212100 (38 pages)
- 315.212100 (4 pages)
- 315.212110 (38 pages)
- 315.212120 (36 pages)
- 315.212130 (36 pages)
- 315.214490 (32 pages)
- 315.214500 (34 pages)
- 315.214770 (32 pages)
- 315.228310 (64 pages)
- 315.228390 (66 pages)
- 315.228410 (8 pages)