phil&teds e3 twin buggy - Manual (Page 9)

six: insert babies
Apply brakes and insert babies and fasten
safety harnesses.
1.
Unclip 4 buckles on breastplate
(circled in green) and place baby
in buggy.
2. Adjust upper straps to fit snugly on
babies’ shoulders.
3.
The breastplate should sit snugly on
each baby’s chest. Adjust side straps
until it sits in correct position. (You
should be able to fit 2 average size
fingers between straps and baby.)
4.
Adjust crotch strap length (under or
over webbing loop) for a comfortable fit.
1.
Attach snaps on back of sunhoods to
higher snaps on handle, both left and
right sides.
five: hooding up
2. Move to front of buggy and secure
snaps on front of sunhoods to seats.
WARNING: Ensure harnesses are used and properly
adjusted at all times.
Note that the windows in the hood are lined with a
sun mesh of a lower shade factor than buggy fabric.
Always use sun cream and clothing for protection of
children in direct sunlight.
7