Т³гж 2 – Perfect Aire PAWS1 User Manual

Page 2

ASSEMBLE THE WALL SLEEVE (CONTINUED)

FIG.A

FIG.B

WALL

First put the assembled sleeve into the wall opening as shown below ,
then place the air conditioner into the sleeve.

SLEEVE

INSTALL THE COVER PANELS (when not using air conditioner for
a long time.)

FIG.C

INSTALL THE COVER PANELS (CONTINUED)

FIG.F

FIG.D

FIG.E

NOTE:To improve the firmness of the sleeve, it is recommended to
install 8 more screws as shown below.

Install two brackets on the top and one bracket on each
side of the sleeve, fasten with four screws.There are two
methods for your choice to install the brackets as shown
in FIG. A and FIG.B.
NOTE: Choose anyone hole in the bracket as you prefer
to fasten the screws on the sleeve.

To install cover panel at the back of sleeve,first remove air conditioner
from sleeve.
Take the louvered rear grille or the expanded rear grille out by
loosening the four washer screws as shown in FIG.C.
From the inside of the sleeve,insert the rear cover panel and re-insert
the four washer screws through the panel,then tighten them as shown
in FIG.D and FIG.E.
Use the front panel to cover the front of the sleeve. Fasten with 4
screws as shown in FIG.F.

CW031I-TTWQT 202000192293 20110630

Expanded rear grille

Louvered rear grille