Perfect Aire PACH8000 - Manual (Page 9)

on off
Timer
Temp/Timer
On/off
Temp/Timer
Fan Speed
Check
Filter
Sleep
Follow Me
Auto
Low
Med
High
on off
Timer
Temp/Timer
Energy
Saver
Temp/Timer
Auto
Cool
Dry
Fan
Mode
Heat
TIMER: AUTO START/
STOP FEATURE:
Press Timer
button
DO THIS:
AIR CONDITIONER FEATURES(CONTINUED)
NOTE:
CHECK FILTER FEATURE:
Press Check
Filter button
DO THIS:
This feature is a reminder to clean the Air Filter for
more efficient operation. The LED(light) will illumi-
nate after 250 hours of operation. To reset after
cleaning the filter, press the Check Filter button and
the light will go off.
NOTE:
8
FOLLOW ME FEATURE:
(on some models)
Light flashing
NOTE:
To activate the Follow Me feature, point the remote
control towards the unit and press the Follow Me
button. T
If the unit
does not receive the Follow Me signal during any 7
minutes interval, the unit will beep to indicate the
Follow Me mode has ended.
he remote display is actual temperature
at its location. The remote control will send this
signal to the air conditioner every 3 minutes
until press the Follow Me button again.
This feature can be activated from the remote
control ONLY. The remote control serves as a
remote thermostat allowing for the precise
temperature control at its location.
on off
Timer
Temp/Timer
On/off
Temp/Timer
Fan Speed
Check
Filter
Sleep
Follow Me
Auto
Low
Med
High
- When the unit is on or off, first press the Timer button,
the TIMER ON indicator light illuminates. It indicates
the Auto Start program is initiated.
- When the time of TIMER ON is displayed
- Press or hold the UP or DOWN button to change the
Auto time by 0.5 hour increments, up to 10 hours, then
at 1 hour increments up to 24 hours. The control will
count down the time remaining until start.
- The selected time will register for 5 seconds, and the
system will automatically revert back to display the
previous temperature setting or room temperature when
the unit is on.(When the unit is off, there is no display.)
- Turning the unit ON or OFF at any time or adjusting
the timer setting to 0.0 will cancel the Auto Start/Stop
timed program.
, press the
Timer button again, the TIMER OFF indicator light
illuminates. It indicates the Auto Stop program is
initiated.
on off
Timer
Temp/Timer
Energy
Saver
Temp/Timer
Auto
Cool
Dry
Fan
Mode
Heat
DISPLAYS:
Displays
O O Shows the set temperature in F or C and the
Auto-timer settings. While on Fan only mode,it shows
the room temperature.
DISPLAYS:
-Evaporator temperature sensor error-Unplug the
unit and plug it back in.If error repeats, call for
service.
NOTE: is displayed as shown in the left picture.
HS -Electric heating sensor error-Unplug the unit and
plug it back in.If error repeats, call for service.
Error codes:
AS-Room temperature sensor error-Unplug the unit
and plug it back in.If error repeats, call for service.
NOTE:In Fan only mode,it will display LO or HI .