Dehumidifier features, Filter pump fan timer – Perfect Aire PMP50 User Manual
Page 5

Fig.3
Auto defrost operation on
indicator light
High fan
indicator light
Filter
Pump
Fan
Timer
Filter
Full
Pump
On Off
Turbo
Auto defrost
Clean filter
indicator light
Bucket full
indicator light
Pump operation
on indicator light
Timer on/off
indicator light
Cont.
Continuous
operation on
indicator light
DEHUMIDIFIER FEATURES
4
NOTE: The control panel of the unit you purchased may be slightly different based on the model.
CONTROL PADS
When you push the button to change operation
modes, the unit will make a beep sound to indicate
that it is changing modes.
PUMP Pad
Press to activate the pump operation.
NOTE: Make sure the pump drain hose is
installed into the unit and the continuous drain
hose is removed from the unit before the pump
operation is activated. When the bucket is full,
the pump starts to work. Refer to the next pages
for removing the collected water. Do not use this
operation when the outdoor temperature is equal
to or less than 32°F (0°C).
FILTER Pad
The check filter feature is a reminder to clean the
air filter for more efficient operation. The Filter
light (Clean Filter light) will illuminate after 250
hours of operation. To reset after cleaning the
filter, press the Filter pad and the light will go off.
FAN Pad
Controls the fan speed. Press to select either
Turbo (High) or Normal fan speed. Set the fan
control to Turbo for maximum moisture removal.
When the humidity has been reduced and quiet
operation is preferred, take the fan off of Turbo so
the unit runs on Normal.
POWER Pad
Press to turn the dehumidifier on and off.
DOWN – & UP + Pads
Humidity Set Control Pads
The humidity level can be set within a range of
35% RH (Relative Humidity) to 85% RH in 5%
increments. For drier air, press the –
pad and set
to a lower percent value (%). For damper air, press
the + pad and set to a higher percent value (%).
Timer Set Control Pads
Use the Up/Down pads to set the Auto start and
Auto stop time from 0.0 to 24 hours.
Continuous Operation
To run the unit in continuous mode, press the –
pad until the display reads 35% RH. Then press
the –
pad again until the display reads “CO” for
continuous operation. To stop continuous
operation, press the
+ and set the desired % RH
set point level to resume normal operation.
NOTE: You cannot set a desired humidity while
in continuous mode. Continuous mode means
the dehumidifier will run all the time and does not
need a humidity setting.
TIMER Pad
Press to initiate the auto start and auto stop
feature in conjunction with the
+ and – pads.
Display
Shows the set % humidity level from 35% to 85%
or auto start/stop time (0−24) while setting, then
shows the actual (5% accuracy) room % humidity
level in a range of 30% RH to 90% RH.