Philips AZ2710-17 - Manual (Page 4)

Í№UÍRS
Attaching the speakers
• Slide the speakers down into the sleeves on the sides of the set
cabinet. The speakers will click into position.
Taking off the speakers
• Keep the lever (found on the back corner of the speaker) pressed and
slide the speaker upwards.
Connecting the speakers
I. Connect the right speaker to the terminal R, with the red marked wire
to + and the black wire to
Z Clip the exposed portion of wire into the corresponding colour terminal.
3. Repeat the wiring procedure for the left speaker to terminal L making
sure that you connect the red wire to f and die black wire to -.
Positinaing tha spaakars
The ideal position is obtained when the 2 front speakers and the listening
position build an equilateral triangle and the speakers are at ear-height.
Note:
- Speakers with an impedance of 4 ohms or higher other than as
supplied may be used instead. Do not, however, use speakers with a
lower impedance as this will result in damage to your set
- When headphones are connected with the headphone socket O
the speakers are disconnected.
General operation
1. To switch on the set, set the source by using the source selector Cs).
2. Adjust the sound using the VOLUME AT@, TONE ® and DBB @
controls.
3. To switch off the set, set the source selector® to TAPE/OFF position,
with the cassette keys released.
I. Set the source selector ® to TUNER.
■Z Adjust the sound using the VOLUME a ▼ ®, TONE ® and DBB (|)
controls.
JL Select the wave band using the BAND selector#.
4. Tune to a radio station using the TUNING knob
To improve radio reception
- For FM, pull out the telescopic antenna. To improve FM-reception,
incline and turn the antenna. Reduce its length if the FM-signal is too
strong (very close to a transmitter).
- For AM, the set is provided with a built-in antenna, so the telescopic
antenna is not needed. Direct the antenna by turning the whole set.
SL To switch off the set, set the source selector ® to TAPE/OFF.