Sound - using i in: audio/vidi:o [npu r jacks – Philips 26LL500 User Manual

Page 36

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

o u n d

- U

s i n g

i n : A

u d i o

/ V

i d i

:o [

n p u

r J

a c k s

Ai i)io/\'ii)i:o

m t i s

"he TV’s audio/video input
jacks are for direct picture
and sound connections between

the TV and a VCR (or similar
device) that has audio/video out

put jacks.

<1> Connect the VIDEO (yeUow)

cable to the VIDEO AVI jack on
the back of the TV. Then con
nect the AUDIO (red and

white) cables to the AUDIO (left
and right) AVI jacks on the rear

of the TV.

<|> Connect the VIDEO (yellow)

cable to the VIDEO OUT jack
on the back of the VCR. Then
connect the AUDIO (red and
white) cables to the AU DIO (left
and right) OUT jacks on the rear
of the VCR.

Turn the VCR and the TV

Press

the

SOURCE

button

on the remote control until the
AVI source is selected. After
AVI appears, insert a prerecord
ed tape into die VCR and press
the PLAY button to view uie tape
on the television. If AVI did not
appear, perform steps 5-9.

NOTE: the actions described in
steps 5-9 are not illustrated on
this page.

If AVI did not appear

onscreen as one of the choices

available to you by pressing the
SOURCE button, press the
M Link button on the remote
control to display the M-Link”
onscreen menu..

Press

the

CURSOR

RIGHT

I or CURSOR LEFT button to
I highlight CVI.

<|> Press the CURSOR UP but-

I ton to toggle from CVI to AVI.

Press the STATUS/EXrr

button to remove the M-Link™

menu from the screen.

Press the SOURCE button to

tune the AVI source. You are
now ready to view the VCR tape
on the TV.