beautypg.com

System connection, How to avoic damaging surfaces, Nozzle cleaning instruction – Campbell Hausfeld IN468001AV User Manual

Page 6

background image

www.chpower.com

6

System connection

1. Insert lance into the gun and turn

clockwise to positive stop as shown
in Figure 5.

2. Be sure that the power switch is in

the “OFF” position.

3. Attach the high pressure hose onto

the pump water outlet by turning
clockwise and hand tightening. Be
certain to push hose onto pump
while tightening. Be careful to not
cross thread the hose.

4. Connect garden hose as explained

under Garden hose connection
Instructions
.

5. Plug the power cord into a

grounded 120V outlet.

6. Turn water on.

7. Unlock trigger lock by moving lock

right to left.

8. Depress and hold the trigger on

the gun for one minute to release
pressure and remove any air trapped
in the system.

9. Turn the “ON/OFF” switch to the

“ON” position, while pulling the
trigger.

Operating Instructions and Parts List

PW1350

Figure 5 - Gun/Lance connection

ON

OFF

Figure 6 - ON/OFF Switch

how to Avoic Damaging
Surfaces

Directions for use
Damage to cleaning surfaces occurs
because the impact force of the water
exceeds the durability of the surface. You
can vary the impact force by controlling
the nozzle’s fan pattern, the nozzle’s
angle to the cleaning surface, and the
nozzle’s distance from the cleaning
surface. Never use a narrow high impact
stream or a turbo nozzle on a surface
that is susceptible to damage. Avoid
spraying windows with a narrow high
impact stream or turbo nozzle. Doing so
may break the window. The surest way
to avoid damaging surfaces is to follow
these steps:

1. Before triggering the gun, adjust

the nozzle to a wide fan pattern.

2. Place the nozzle approximately 4-5

feet away from the cleaning surface.
Then hold the nozzle at a 45° angle
to the cleaning surface. Trigger the
gun.

3. Vary the fan pattern spray angle and

the distance to the cleaning surface
until optimum cleaning efficiency
is achieved without damaging the
surface.

Nozzle cleaning Instruction

A clogged or partially clogged nozzle can
cause a significant reduction of water
coming out of the nozzle and cause the
unit to pulsate while spraying.

To clean out the nozzle:

• Turn off unit.

• Turn off water supply. Relieve any

pressure trapped in the hose by
squeezing trigger 2-3 times.