Campbell Hausfeld IN468001AV - Manual (Page 4)

www.chpower.com
4
Servicing of a Double-
Insulated Appliance
In a double-insulated product, two
systems of insulation are provided instead
of grounding. No grounding means are
provided for a double-insulated product,
nor should grounding means be added to
the product. Servicing a double-insulated
product requires extreme care and
knowledge of the system, and should be
done only by qualified service personnel.
Replacement parts for a double-insulated
product must be identical to the original
parts. A double-insulated product
is marked with the words “Double
Insulation” or “Double Insulated.”
Product may also be marked with symbol
shown below.
Do not use
pressure that
exceeds the operating pressure of
any of the parts (hoses, fittings, etc.)
in the pressurized system. Ensure all
equipment and accessories are rated
to withstand the maximum working
pressure of the unit.
Explosion hazard.
• NEVER spray flammable liquids or use
pressure washer in areas containing
combustible dust, liquids or vapors.
• NEVER operate this machine in a closed
building or in or near an explosive
environment.
Do not spray
electrical
apparatus and wiring.
• NEVER disconnect the high pressure
discharge hose from the machine
while the system is pressurized. To
depressurize machine, turn power
and water supply off, then press gun
trigger 2-3 times.
• NEVER permanently engage the trigger
mechanism on the gun.
• NEVER operate the machine without
all components properly connected
to the machine (handle, gun/wand
assembly, nozzle, etc.).
Equipment
damage.
• ALWAYS turn water supply “ON”
before turning pressure washer “ON.”
Running pump dry causes serious
damage.
• Do not operate the pressure washer
with the inlet water screen removed.
Keep screen clear of debris and
sediment.
• NEVER operate pressure washer
with broken or missing parts. Check
equipment regularly and repair
or replace worn or damaged parts
immediately.
• Use only the nozzle supplied with this
machine.
• NEVER leave the wand unattended
while the machine is running.
• NEVER attempt to alter factory
settings. Altering factory settings could
damage the unit and will void the
warranty.
• ALWAYS hold gun and wand firmly
when starting and operating the
machine.
• NEVER allow the unit to run with the
trigger released (off) for more than
one (1) minute. Resulting heat buildup
will damage pump.
Operating Instructions and Parts List PW1350
Double Insulated symbol