Philips MC-320-37 - Manual (Page 16)

Radio Reception
Tuning to radio stations
1 Select TUNER source.
TuiJER is displayed briefly.
2 Press BAND (or DISPLAY on remote control)
once or more to select your waveband(FM/
AM).
3 Press down TUNE « or » and release
button.
-> The radio automatically tunes to a station
with sufficient reception. Display indication
during automatic tuning: 5CRRCH.
If a FM station is received in stereo, CD is
shown.
4 Repeat step 3 if necessary until you find the
desired station.
• To tune to a weak station, press TUNE « or
» briefly and repeatedly until you have found
optimal reception.
Programming radio stations
You can store up to a total of 40 radio stations
in the memory.
Automatic programming
Automatic programming will start with a
chosen preset number. From this preset number
upwards, former programmed radio stations will
be overridden.The system will only program
stations which are not in the memory already.
Press PRESET l< or >1 to select the preset
number where programming should start.
Note;
- If no preset number is selected, default is
preset (1) and all your presets will be overridden.
Press PROG (PROGFtAM on remote control)
for more than 2 seconds to activate
programming.
Ru'fu is displayed and available stations are
programmed in order of waveband reception
strength: FM followed by AM The last preset
automatically stored will then be played.
Manual programming
1 Tune to your desired station (see "Tuning to
radio stations").
2 Press PROG (PROGFIAM on remote control)
to activate programming.
3 Press PRESET l< or >1 to allocate a number
from 1 to 40 to this station.
4 Press PROG (PROGFIAM on remote control)
again to confirm the setting.
“> The preset number and the frequency of the
preset station are shown.
5 Repeat the above four steps to store other
stations.
• You can override a preset station by storing
another frequency in its place.
Tuning to preset radio stations
• Press PRESET l< or >1 until the desired
preset station is displayed.
16