Cisco 32369 - Manual (Page 23)

hardware-address
Cisco IOS DHCP Server 23
hardware-address
To specify the hardware address of a Dynamic Host Configuration Protocol (DHCP) client, use
the hardware-address DHCP pool configuration command. It is valid for manual bindings only.
Use the no form of this command to remove the hardware address.
hardware-address hardware-address type
no hardware-address
Syntax Description
Defaults
Ethernet is the default type if none is specified.
Command Modes
DHCP pool configuration
Usage Guidelines
This command first appeared in Cisco IOS Release 12.0(1)T.
Examples
The following example specifies b708.1388.f166 as the MAC address of the client:
hardware-address b708.1388.f166
Related Commands
client-identifier
host
ip dhcp pool
hardware-address Specifies the MAC address of the client’s hardware platform.
type Indicates the protocol of the hardware platform. Strings and values are
acceptable. The string options are:
• ethernet
• ieee802
The value options are:
• 1 10Mb Ethernet
• 6 IEEE 802
If no type is specified, the default protocol is Ethernet.