Chauvet CH-175 - Manual (Page 6)

Setup
CH-175 User Manual 6 2004-09-20/13:36
Hanging Clamp
Clamp sold separately!
•
All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat (variable
resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0% to 100%
switch.
•
Before applying power to a fixture, check that the source voltage matches the fixture’s requirement.
•
All fixtures must be connected to circuits with a suitable Earth Ground.
Mounting
It is important never to obstruct the fan or vents pathway. Mount the fixture
using, a suitable “C” or “O” type clamp. Adjust the angle of the fixture by
loosening both knobs and tilting the fixture. After finding the desired
position, retighten both knobs.
• When selecting installation location, take into consideration lamp
replacement access and routine maintenance.
•
Safety cables should always be used.
• Never mount in places where the fixture will be exposed to rain, high humidity, extreme temperature
changes or restricted ventilation.
Top View
Front View
These holes can be used to
mount hanging clamps for
downlighting positions off a
truss
The CH-175 can also be
used for uplighting. The
yoke hardware can equally
serve as floor stands.
Side View