OmniSistem PR Pilot 300 - Manual (Page 7)

The PILOT 300 uses 10 DMX channels. They are listed in the following table.
DMX CONTROL CHANNEL FUNCTIONS
CHANNEL DMX VALUE DESCRIPTION
0-33 Open / Clear (5-7 for 5 secs.) Soft reset – See Note
34-66 (GLASS) GOBO 1
67-99 (METAL) GOBO 2 (Stars)
100-132 (GLASS) GOBO 3
133-165 (METAL) GOBO 4 (Tri-ring)
166-199 (GLASS) GOBO 5
200-232 (METAL) GOBO 6 (Multi-circle)
1
Gobo
233-255 (GLASS) GOBO 7
0-8 Stop
9-163
Orientation from 0°to 360°
164-205 Rotate from slow to fast
206-213 Stop
2
Gobo rotation
214-255 Rotate in opposite direction from slow to fast
0-27 Open
28-55 Red
56-83 Yellow
84-111 Orange
112-139 Blue
140-167
Light green
168-195 Cyan
196-223 Ultraviolet
color
224-251 Pink
3
Colour
252-255 Green
0-13 Black-out
14-195
Open gradually from black to full open (dimming)
196-251 Strobe adjust from slow to fast
4
Strobe/Shutter
252-255 Open
5 Pan 0-255 Pan movement from 0°to 370°
6 Tilt 0-255 Tilt movement from 0°to 265°
7 Focus 0-255 Stepless focus
0-31 Clear
32-48 Prism
static
49-127 Prism Orientation
128-189 Prism rotate from slow to fast
190-193 Prism Static
8
Prism
194-255 Prism rotate from slow to fast in opposite direction
9 Pan 16bit 0-255 16 Bit Pan resolution
10 Tilt 16bit 0-255 16 Bit Tilt resolution
NOTE
Soft Reset – If the DMX value sent on this channel (1) stays in the range from 5 to 7 for more than 5
seconds, the projector will start a reset sequence (Remote Requested Reset). The electronics are re-started
and all motors moved to their home positions exactly as they do when the power is first switched on but the
lamp is not switched off in this sequence, although the beam will be blacked out
.
The channels 9 and 10 are only available when the Setup Option 6 is “ON”.
For the exact setting refer to “Setup Options” section.
The projectors can operate without a controller. They can do this in one of 3 different ways. Stand-Alone
Mode means automatic operation independent of other projectors and can either be automatic or triggered
by music depending on the combination of Setup Options 4 and 5 that are selected.
STAND-ALONE MODES – MASTER / SLAVE
The projectors can also operate synchronously with each other in Master/Slave mode. To do this they must
be connected together as described above in the Control Connections section with the terminator inserted
in the output of the last slave projector in the chain but, of course, without the controller. The same type of
DMX cables must be used to connect the Master with the Slaves. The appropriate Setup Options must also
be set. See the section on “Setup Options – Projector Configuration” for full details of the available
combinations.
Select one projector as the Master, setting the DMX start address at random. Regard the other projectors
as the slaves setting all DMX start addresses to “001”.
pilot300_en.doc 7/14
Never have more than ONE (1) projector configured as Master or the system will not work.