OmniSistem PR Pilot 1200 Wash - Manual (Page 12)

Pilot 1200 wash EN.doc 12/16
LIGHT OUTPUT
33° lux
15° lux
270 420 950 3800
11.8m 8.88m 5.92m 2.96m 0m 33° DIAMETER
15° DIAMETER
DISTANCE
5m
5m
4m
2m
4m
2m
0m
1m
1m
3m
3m
0m
0m
1.3m
5m
2.6m
10m
3.9m
15m
5.2m
20m
22800 5700 2500 1420
PROBLEM POSSIBLE CAUSE ACTION
The projector doesn’t
switch on
­The power supply is not
present
­The lamp doesn’t work Check the fuse on the power
socket.
Replace the lamp.
The lamp comes on but
the projector doesn’t
respond to the controller ­Wrong DMX configuration
and/or start address
­ Defective DMX cable Make sure that the projector is
correctly configurated.
Replace or repair the DMX
cable.
The projector only
functions intermittently
­The fan has failed Make sure the fan is working
and not dirty.
Defective projection ­The lens is broken
­Dust or grease on lenses Check the lenses are not
broken.
Remove dust or grease from
the lenses.
The projected image
appears to have a halo ­Installation of the lamp is
not correct
­Dust or grease
contamination on the
optics. Make sure the lamp is installed
correctly.
Carefully clean the optical
group lenses and the projector
components.
The beam appears dim ­Dust or grease
contamination on the
optics.
­The lamp is at the end of
its life Check the optics is clean.
Replace with a new lamp of the
specified type and rating.
TROUBLESHOOTING