OmniSistem PR Pilot 1200 Wash - Manual (Page 11)

Pilot 1200 wash EN.doc 11/16
Green: ON——DMX signal OK or Slave;
OFF——No DMX signal;
Flash——DMX error;
Red: Medium flash——Menu mode;
Fast flash——software, cpu error;
Both ON: Address mode,
Flash in turn: Master mode.
Pan’s belts
Free 2 screws on Pan assembly’s
maintenance door and open the door;
change the belts; close the door and fasten
the screws.
Tilt’s belts
The common users replacing the belts is not
recommended.
If the projector’s lens becomes damaged or broken it should be replaced. If the lamp
becomes damaged or deformed in any way it must be replaced. If the light from the lamp
appears dim this would normally indicate that it is reaching the end of its life and it should
be changed at once, aged lamps run to the extremity of their life might explode. If the
projector does not function, check the fuses on the power socket of the projector, they
should only be replaced by fuses of the same specification. Should these be damaged call a
qualified technician before replacement. The projector has thermal protection device that
will switch off the projector in case of overheating, should either of these operate, check
that the fans are not blocked, and if they are dirty clean them before switching on the
projector again. Check that the fans are operational, if not call a qualified technician.
Any maintenance work should only be carried out by qualified technicians.
To ensure linear motion of the lens, it is recommended that the 3 shafts for the focusing
lens holder be lubricated periodically, preferably every two months. Use only high quality,
high­temperature resistant grease instead of any type of oil.
To ensure the reliability of the projector it should be kept clean. It is recommended that the
fans should be cleaned every 15 days. The lens and dichroic colour filters should also be
regularly cleaned to maintain an optimum light output. Do NOT use any type of solvent on
dichroic colour filters.
Cleaning frequency depends on the environment in which the fixture operates: damp, smoke
or particularly dirty surroundings can cause greater accumulation of dirt on the unit’s optics.
A soft cloth and typical glass cleaning products should be used in cleaning. It is
recommended to clean the external optics at least once every 20 days and clean the
internal optics at least once every 30 / 60 days.
Do not use any organic solvent, e.g. alcohol, to clean the reflector mirror, dichroic
colour filters or housing of the apparatus.
MAINTENANCE
KEEPING THE PROJECTOR CLEAN
LED DISPLAY
LUBRICATION
CHANGING BELTS
BASE
SCREWS
OPEN THE DOOR
PAN ASSEMBLY'S
MAINTENANCE DOOR