Casio Privia PX3ES1A - Manual (Page 16)

E-14
Selecting and Playing a Tone
Splitting the Keyboard between Two
Tones
1.
Use the “Tone List” (page E-57) to look up the
group(s) and numbers of the two tones
(UPPER 1 zone tone and LOWER 1 zone
tone) you want to use.
2.
Check to make sure that the both the 
(LAYER) and  (SPLIT) button lamps are
unlit.
• If one or both lamps are lit, press the  (LAYER) and
 (SPLIT) buttons to turn them off.
3.
Press the  (UPPER 1) button so its lamp is
lit.
• This indicates you can select the UPPER 1 zone tone.
4.
Select the UPPER 1 zone tone.
• For details about selecting tones, see “To select a
tone” (page E-11).
5.
Press the  (SPLIT) button so its lamp is lit.
• At this time the  (UPPER 1) button lamp will go out
and the  (LOWER 1) button lamp will light in its
place. This indicates you can select the LOWER 1
zone tone.
6.
Select the LOWER 1 zone tone.
7.
Play something on the left and right sides of
the keyboard to confirm that the tones are
assigned properly.
• At any time you can press the  (UPPER 1) button to
change the UPPER 1 zone tone or the  (LOWER 1)
button to change the LOWER 1 zone tone.
8.
To cancel the keyboard split, press the 
(SPLIT) button again so its lamp goes out.
NOTE
• You also can specify the keyboard split point, which
the location where the keyboard splits between the
left range and right range. In initial default split
point is at key F
# 3.
For details, see “To specify the keyboard split point”
(page E-14).
To specify the keyboard split point
1.
Hold down the  (SPLIT) button until the
screen shown below appears.
2.
Press the keyboard key that you want to be
the leftmost key in the right side (UPPER 1
zone) range.
• The name of the key you press will appear on the
display as the new split point key name.
• You also can use the  (w, q) buttons to change
the split point key name.
3.
When you are finished, press the  (SPLIT)
button.
LOWER 1 UPPER 1
Lit
Unlit
Lit
Lit
LOWER 1 zone
Split point
UPPER 1 zone
Current split point key name