NORAC UC5-BC-HG02 - Manual (Page 27)

24
Figure 21: Valve Module Bracket Installation
5. Connect the valve module CANbus to cable C01 from the chassis roll sensor. Route cable
C03 from the other CANbus connector to the input module.
6. With the valve module securely mounted to the valve block, connect the valve cables (C10),
to the valve coils. Insert the 2-pin plugs (P01) into the unused 2-pin connectors on the
valve module.
7. Connect the temperature probe to the valve block using the supplied 3/8” x 1/2” hex bolt.
Figure 22: Valve Module - Valve Coil Connections
Tank Port
Pressure Port
Sense Port
Left Tilt Ports
Right Tilt Ports