NORAC UC5-BC-HG02 - Manual (Page 18)

15
7 Roll Sensor Installation
7.1 Bracket Assembly
1. Securely mount the roll sensors to the included roll sensor brackets using the #6 machine
screws. Tighten screws to 10 in-lbs (1.1 Nm).
2. The orientation of both roll sensors to the roll sensor bracket will depend on the bracket
mounting. The roll sensor CANbus connector must be pointing towards the right side of
the sprayer when looking from the rear of the sprayer.
Figure 11: Mounting Roll Sensor to Bracket
Figure 12: Roll Sensor Orientation - Connector Facing Right Wing