9 module installation, 1 control module – NORAC UC5-BC-HG01 User Manual
Page 24
21
9 Module Installation
An optional module mounting bracket kit is available for purchase from NORAC. The
mounting brackets are compatible with control modules and input modules. One kit is needed
per module.
Item
Part Number
Name
Quantity
B20
43708
UC5 MOUNTING BRACKET KIT (CONTROL AND INPUT MODULES)
1
9.1 Control Module
1. Refer to Figure 2 and Figure 18.
2. Securely mount the control module (E01) inside the sprayer cab using screws, cable ties or
optional brackets.
3. Connect the display terminal to the control module. This display cable must be connected
to the end of the control module with only one Deutsch connector.
4. Connect the power cable (C30) to one of the two CANbus connectors on the control
module. Connect the other end of the power cable to the terminal strip in the cab. Be
sure that the power is connected to a switched power supply.
5. Route cable C01 from the other CANbus connector, through the cab knock outs and
towards the front left hand wheel.
Figure 18: Control Module Mounting