beautypg.com

8 module installation, 1 control module – NORAC UC5-BC-TA01 User Manual

Page 23

background image



20

8 Module Installation

An optional module mounting bracket kit is available for purchase from NORAC. The
mounting brackets are compatible with control modules and input modules. One kit is needed
per module.

Item

Part Number

Name

Quantity

B20

43708

UC5 MOUNTING BRACKET KIT (CONTROL AND INPUT MODULES)

1

8.1 Control Module

1. Refer to Figure 1 and Figure 20.

2. Securely mount the control module (E01) in the cab or on the sprayer, using screws, cable

ties or optional brackets. Refer to the display kit installation manual to determine the best
mounting location.

3. Connect the display terminal to the control module using the display CANbus cable This

cable must be connected to the end of the control module with only one Deutsch
connector.

4. Connect the power cable (C30) to one of the two CANbus connectors on the control

module. Connect the other end of the power cable to an appropriate power source.

5. Connect cable C02 to the other CANbus connector and to the 2-way coupler (E12).

Route cable C01 from the other connector on E12 towards the rear of the sprayer.

NOTE: Cable C02 and the 2-way coupler (E12) are used to provide a hitch disconnect if the

control module is mounted on the tractor. If the control module is mounted on the

sprayer, they may not be needed.

Figure 20: Control Module Mounting