NORAC UC5-BC-TA01 - Manual (Page 12)

9
4.6 Alternate Cabling
Some Top Air sprayers may require different cabling depending on the connectors used near
the valve block. Please refer to the table below for ordering alternate cabling from NORAC. A
complete list of alternate cabling can be found in the UC5 Generic Cable Ordering Guide (P/N:
UC5-BC-CABLE-GUIDE) which is available at www.norac.ca.
Item Part Number Name Connector Picture
C20 43240-01* CABLE UC5 INTERFACE TILT DT Deutsch DT
C21 43240-07*
CABLE UC5 INTERFACE MAIN DT
(WITH AUX 1 & 2)
Deutsch DT
C20 43240-11 CABLE UC5 INTERFACE TILT DIN DIN
C21 43240-12
CABLE UC5 INTERFACE MAIN DIN
(WITH AUX 1, 2 & 3)
DIN
* Supplied with kit.
Do not use high speed power tools/drills when installing hardware.
The use of dielectric grease is not recommended on any NORAC electrical
connections.
To ensure all stainless steel hardware does not gall or seize apply a light coating of
the supplied Permatex Anti-seize grease to all threaded parts upon installation.
Permatex Anti-seize lubricant is preferred, but other similar anti-seize products
may be used.