NORAC UC5-BC-JD07A - Manual (Page 36)

33
8. Disconnect the existing hoses from the tilt cylinders. Remove the existing 90 degree fitting
on the rod end of each cylinder as well. Install a 6FORXR-6MORT fitting (F03) onto the
ports of each tilt cylinder. Reconnect the cylinder hoses and 90 degree fittings to the newly
installed tees.
9. Connect one end of hoses H02 to the F03 fittings on the LEFT tilt cylinder. Connect the
other end of hoses H02 to the NORAC valve block “A” and “B” ports.
10. Connect one end of hoses H04 to the F03 fittings on the RIGHT tilt cylinder. Connect the
other end of hoses H04 to the NORAC valve block “A” and “B” ports.
11. The “raise” lines must be connected to the "B" ports of the NORAC valve block.
12. The “lower” lines must be connected to the "A" ports of the NORAC valve block.
13. Install hoses H72 to the roll cylinder that was previously installed. Route the hoses to the
NORAC valve block. Connect the hose attached to the rod end of the cylinder to the “B”
port of the 3
rd station of the block. Connect the hose attached to the cap end of the
cylinder to the “A” port of the 3 rd station of the block.
14. Install the load sense line (H01) onto the 4MB-4MOR fitting (F06) installed in the “S” port
of the NORAC block. Route the load sense line (H01) to the shuttle valve manifold located
underneath the sprayer. Tee the load sense line (H01) directly in to the “S” port of the
shuttle valve manifold using F03 and F04.
There are multiple versions of JD load sense blocks on sprayers. Choose the
picture that most closely resembles the sprayer valve block and tee in
accordingly.
On some installs the Load sense hose (H01) may be too long and the excess
hose must be coiled and secured where it will not interfere with other
components.