beautypg.com

NORAC UC5-BC-JD07A User Manual

Page 28

background image



25

7. Remove the plug from the Sense Line Bleed port. Location is shown in Figure 23. Gently

tap the plug with a hammer to loosen it before attempting to remove it. To access bleed
orifice, remove the valve coil that is covering it, by unscrewing the nut on the coil.

8. Remove the Sense Line Bleed Orifice and discard.

9. Install the setscrew (F11) into the Sense Line Bleed Orifice location. Ensure the setscrew

is threaded entirely into the hole and tightened to 35-40 in-lbs to ensure a tight seal.

10. Reinstall the plug and tighten to 3 ft-lbs (4Nm).

Figure 23: Load Sense Bleed Orifice Location on Top of Block

Remove

this coil