beautypg.com

3 input module – NORAC UC5-BC-JD07A User Manual

Page 25

background image



22

8.3 Input Module

1. Install the input module (E03) on the boom near the sprayer valve block. Secure it to the

boom using cable ties or optional brackets.

2. Connect the free end of the CANbus cable (C02) from the valve module to the input

module. Connect cable C03 to the other CANbus connector and route to the 8-way
coupler.

3. Insert the 12 pin plug (P02) into the OEM 3 connector on the end of the input module

Figure 21: Input Module Connections

4. Connect the 12 pin connector on the tilt interface cable (C20) to the Thru 2 connector on

the side of the input module. Insert the other connectors on C20 into the tilt connectors
on the John Deere solenoids.

5. Connect the 12 pin connector on the main lift interface cable (C21) to the Thru 1

connector on the side of the input module. Insert the other connectors on C21 into the
main lift connectors on the John Deere solenoids.

6. Connect the two Deutsch connectors on the long cable on C21 together. Coil the cable

up and tie it where it will not interfere or catch on anything. These connectors are not
used.

There is one set of different connectors included with the tilt interface cable.

Some John Deere sprayers use this connector on the left down function. If the
sprayer has this connector, remove the existing connectors using the included pin
removal tool. Insert the wires into the new connector and ensure they are in the
same position as they were in the previous connector.