NORAC UC5-BC-HD08 - Manual (Page 32)

29
10 Connecting the Sensors to the CANbus
1. Fasten the 8-way coupler to the boom with cable ties.
2. Route cable C03 from the valve module to the 8-way coupler (E11).
3. Connect both roll sensors to the 8-way coupler.
4. Connect the main lift sensor to the 8-way coupler using cable C01 and a 2-way coupler
(E12). Cable C01 and item E12 may not be needed if the 8-way coupler is mounted close
enough to the main lift sensor.
5. Connect two cables (C05) to the 8-way coupler and route along the booms to the wing
sensors. Follow existing cables and hoses to be sure the cable will not be pinched or
stretched.
6. At the sensor brackets, attach a 2-way coupler with terminator (E20) to the sprayer boom.
The 2-way coupler with terminator is the white two way coupler. Plug the sensor and the
CANbus cable into the 2-way coupler.
7. Insert the 6-pin plugs (P03) into the unused connectors on the 8-way coupler.
Follow existing cables and hoses to be sure the cable will not be pinched or
stretched.
Ensure that all unused connectors are plugged with the plugs provided.