NORAC UC5-BC-FT03 - Manual (Page 25)

22
9 Connecting the Sensors to the CANbus
1. Fasten the 8-way coupler (E11) to the boom with cable ties.
2. Route cable C03 from the input module to the 8-way coupler.
3. Connect both roll sensors to the 8-way coupler.
4. Connect the main lift sensor to the 8-way coupler using cable C02 and a 2-way coupler
(E12). Cable C02 and item E12 may not be needed if the 8-way coupler is mounted close
enough to the main lift sensor.
5. Connect two cables (C05) to the 8-way coupler and route along the booms to the wing
sensors. Follow existing cables and hoses to be sure the cable will not be pinched or
stretched.
6. At the sensor brackets, attach a 2-way coupler with terminator (E20) to the sprayer boom.
The 2-way coupler with terminator is the white two way coupler. Plug the sensor and the
CANbus cable into the 2-way coupler.
Ensure that all unused connectors are plugged with the plugs provided.