8 module installation, 1 control module – NORAC UC5-BC-FT03 User Manual
Page 21
18
8 Module Installation
An optional module mounting bracket kit is available for purchase from NORAC. The
mounting brackets are compatible with control modules and input modules. One kit is needed
per module.
Item
Part Number
Name
Quantity
B20
43708
UC5 MOUNTING BRACKET KIT (CONTROL AND INPUT MODULES)
1
8.1 Control Module
1. Refer to Figure 1 and Figure 19.
2. Securely mount the control module (E01) in the cab or on the sprayer using screws, cable
ties or optional brackets. Refer to the display kit instructions to determine the best
mounting location.
3. Connect the display terminal to the control module using the display CANbus cable. This
cable must be connected to the end of the control module with only one Deutsch
connector.
4. Connect the power cable (C30) to one of the two CANbus connectors on the control
module. Connect the other end of the power cable to an appropriate power source.
5. Route cable C01 from the other CANbus connector towards the rear of the sprayer.
Figure 19: Control Module Mounting