NORAC UC5-BC-CS05 - Manual (Page 31)

28
7. Attach the straight 6FORX fittings on hoses H05 to the “A” and “B” ports on the expansion
block. Route the free end of the hoses (H05) to the Case main lift tee, which is located
near the sprayer axle (Figure 31).
Figure 31: Case Main Lift Tee Location
8. Disconnect the “raise” hose that runs from the Case valve block to the main lift tee and
install the 6FORX 6MORT fitting (*F03). Reconnect the “raise” hose to the tee.
9. Connect the NORAC hose (H05) that is connected to the B port on the NORAC
expansion block to the tee fitting (*F03).
10. Disconnect the “lower” hose that runs from the Case valve block to the main lift tee and
install the 6FORX 6MORT fitting (*F03). Reconnect the “lower” hose to the tee.
11. Connect the NORAC hose (H05) that is connected to the A port on the NORAC
expansion block to the tee fitting (*F03).