NORAC UC5-BC-CS05 - Manual (Page 22)

19
8 Module Installation
An optional module mounting bracket kit is available for purchase from NORAC. The
mounting brackets are compatible with control modules and input modules. One kit is needed
per module.
Item Part Number Name Quantity
B20 43708 UC5 MOUNTING BRACKET KIT (CONTROL AND INPUT MODULES) 1
8.1 Control Module
1. Refer to Figure 1 and Figure 20.
2. If using a Case AFS Pro 300, 600 or 700 display, follow the control module mounting
instructions in the display kit installation manual. Otherwise, securely mount the control
module (E01) inside the sprayer cab using screws, cable ties or optional brackets.
3. Connect the display terminal to the control module using the existing display cable. This
cable must be connected to the end of the control module with only one Deutsch
connector.
4. Connect the power cable (C30) to one of the two CANbus connectors on the control
module. Connect the other end of the power cable to an appropriate power source.
5. Route cable C01 from the other CANbus connector towards the rear of the sprayer.
Figure 20: Control Module Mounting