NORAC 4468BC+ - Manual (Page 9)

7
4.3 C
OMPLETING THE
I
NSTALLATION
1. Start up your sprayer and test the
sprayer’s functionality. The NORAC
Control Panel does not need to be
powered up for the original switches to
function. Unfold the booms and
raise/lower each boom and main
section.
Again confirm that the
cabling/hoses are agreeable to
the entire range of motion.
2. If any functions do not work, review the
hydraulic and electrical portions of this
manual to check for proper installation.
If you still have trouble, contact
NORAC for assistance.
Before continuing, the control
panel must be updated to
software version 7 or higher.
3. Turn on the power for the UC4+
Control Panel using the switch on the
side of its chassis.
4. Begin the AUTOMATIC SYSTEM
SETUP procedure as described in the
UC4+ Sprayer Boom Control
Operator’s Manual.