NORAC 4468BC+ - Manual (Page 8)

6
4.2 C
ABLE
I
NSTALLATION
1. At the rear of the sprayer, near the
NORAC valve block should be a cable
with 6 connectors.
2. Locate the round AMP connector and
insert cable C01 between the two
connectors (Figure 4).
3. Route the long part of cable C01
towards the chassis roll sensor and
connect it.
4. Cable tie the cables to existing wires and
hoses. Be sure the cables will not be
stretched or rubbed by any moving
parts.
Figure 4: Cable Connections at Rear of Sprayer
Only components shown in black are included with this kit.