NORAC UC4+SM3-4B - Manual (Page 11)

8
4.2 E
LECTRICAL
I
NSTALLATION
Figure 6: Cable Connections at Rear of Sprayer
Only the components shown in
black are included in this kit.
1. Connect the six pin shroud (T6B) to
the mating tower on the valve extension
cable (previously installed).
2. Disconnect the existing C13 cable and
install the 3 pin connectors between it
and the valve extension cable.
One connector on C17 will
remain disconnected. It is used
when installing other UC4+
options.
3. Install the two connectors on the end of
cable C17 to the expansion block.
The connector marked “Main
Up” goes on the port side of the
block. The port side of the block
is the side with the hoses.
4. Disconnect the valve extension cable
from the sensor cable and install cable
C05 between them.
5. Connect roll sensor E01 to cable C05.